Manuals / Konica Minolta / Photography / Digital Camera

Konica Minolta KD-500Z user manual FCC Compliance Statement

Models: KD-500Z

1 125

Download 125 pages 13.14 Kb

Page 123

FCC Compliance Statement:

FCC Compliance Statement:

Declaration of Conformity

Responsible party: KONICA PHOTO IMAGING

Address: 725 Darlington Avenue Mahwah, NJ 07430, U.S.A.

Telephone number: (201) 574-4000

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

•Shielded cables must be used for this equipment to comply with the relevant FCC regulation.

•Power requirement is DC 4.2V ± 10% and 1.5 A max.Use only listed certified power supply adapter.

•The user is cautioned that changes and modifications made to the equipment without approval of the manufacturer could void the user’s authority to operate this equipment.

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

•However, note that operation of this unit near a radio or television receiver could possibly cause radio disturbance.

123

Image 123

Konica Minolta KD-500Z user manual FCC Compliance Statement

Contents

Digital Still Camera User’s GuideTest shooting Results are not guaranteedGetting Started Please be sure to read this manual before useAdvanced Shooting ContentsPreparation Basic OperationContents Cont’d Basic Playback/ErasingAdvanced Playback/Erasing Installing software from the CD-ROM supplied Advanced OperationsOthers Contents Cont’dDefinitions of the symbols Important Safety PrecautionsDo not dismantle, modify or repair the camera yourself Important Safety Precautions Cont’dIf liquid gets inside the camera If any foreign object gets inside the cameraDo not use the flash near eyes Do not directly look at the sun through the viewfinderDo not use AC adapters other than those specified Do not point the lens directly at the sun or at a strong light sourceUnstable surfaces such as on an unstable table or an angled surface Do not use batteries which have become soiled with oil or sweatDo not leave the camera in locations such as Within the reach of childrenAbout the LCD monitor About battery fluid leakageDo not use force when operating the camera Do not rotate the camera when mounting on a tripodPreparation Necessary AccessoriesChecking the Packing Contents This product can be used with the following power suppliesSD Memory Card MultiMedia Card Memory Stick Necessary Accessories Cont’dCompatible Recording Media About the SD Memory Card/Multi-Media Card/Memory StickAlways back-up important data Necessary Accessories Cont’dCamera Body Names of PartsPlay Button→ P.16 Names of Parts Cont’dBattery Sub-cap Battery/Card Coverw Display Button Operation ButtonsNames of Parts Cont’d q Play ButtonAttaching the Strap Charging the supplied Battery Pack Preparing the Power SupplyPreparing the Power Supply Cont’d Installing the supplied Battery PackBattery level indicator With LCD Monitor On Battery life guide referenceNumber of Pictures ContinuousThis product uses a lithium battery FCC Compliance StatementPreparing the Power Supply Cont’d Please co-operate in recycling the lithium batteryPreparing the Power Supply Cont’d Connecting the AC Adapter sold separatelyTurning the Power ON/OFF Setting the Menu Language/Date and Time or the MENU/SET button Setting the Menu Language/Date and Time Cont’d2 Use or to adjust the month in the same way as Step 3 on page 7. After finishing the settings…Inserting/Removing Cards Open the battery/card cover Inserting/Removing Cards Cont’dInserting a Card Inserting/Removing Cards Cont’d Card RemovalHolding Your Camera Viewfinder and Indicator LEDsBasic Operation Taking PicturesTaking Pictures Cont’d Viewfinder LED IndicatorsTaking Pictures Cont’d Taking Pictures using the ViewfinderOnce the red and green LEDs disappear, the recording has finished Taking Pictures Cont’dTaking Pictures Cont’d When you press the shutter halfway and the green LED flashes…Shooting with Focus Lock The following subjects may be difficult to bring into focusTaking Pictures Cont’d Taking Pictures Cont’d Taking Pictures using the LCD Monitorq w e r Image Displayu Battery Remaining Display Taking Pictures Cont’do Shooting Date and Time About Auto Power Off FunctionTaking Pictures Cont’d i CounterSelecting the Shooting Mode Flash Shooting Distances Switching the Flash Mode AUTO Auto FlashSelecting the Shooting Mode Cont’d Red-Eye ReductionSelecting the Shooting Mode Cont’d Fill-InSlow-Sync Off Flash OverrideMacro-photo Mode Using the Self-Timer Self-Timer ModeShooting Close Up/Long Range Macro-photo Mode Distant View ModeUsing the REC Menu Setting with the REC DETAILS MenuAdvanced Shooting For details of each set-up menu, refer to the pages hereafter Using the REC Menu Cont’dUsing the REC Menu Cont’d Returning to Default SettingsSelecting a Combination of Image Sizes and Compression Ratios 3. Select the picture sizeUsing the REC Menu Cont’d Using the REC Menu Cont’d 4. Selecting the compression ratio3 1600 ⋅ 1200 pixels approximately 1,920,000 pixels Image size and pixel count width ⋅ height1 2592 ⋅ 1944 pixels approximately 5,040,000 pixels 2 2048 ⋅ 1536 pixels approximately 3,140,000 pixelsUsing the REC Menu Cont’d Shooting MoviesYou need not hold the shutter button down Using the REC Menu Cont’dUsing the REC Menu Cont’d Adjusting Exposure CompensationUsing the REC Menu Cont’d Adjusting White BalanceAvailable Modes About White BalanceUsing the REC Menu Cont’d Adjusting the Brightness of the LCD MonitorUsing the REC Menu Cont’d Using the Digital ZoomUsing the REC Menu Cont’d Center-weighted meteringChanging Auto-Exposure AE Modes Spot meteringUsing the REC Menu Cont’d Changing to the Slow Shutter Speed ModeUsing the REC Menu Cont’d Making Voice MemosUsing the REC Menu Cont’d Using After RecordingErasing recorded voice comments Using the REC Menu Cont’dthe appropriate setting, and then press the MENU/SET button Using the REC Menu Cont’d Taking Monochrome PicturesUsing the REC Menu Cont’d Selecting the Set-up MenuUsing the REC Menu Cont’d Setting with the REC BASIC MenuAbout 85 photos Selecting the Image SizeUsing the REC Menu Cont’d About 51 photosPage Basic Playback/Erasing PlaybackPlaying Back Pre-recorded Images q Recording Media Display Playback Cont’dThe Playback Image Display t Remaining Battery Power DisplayPlayback Cont’d Playing Back MoviesPlayback Cont’d Playing Back Voice MemosPlayback Cont’d Playing Back Enlarged Images Digital ZoomUsing the Quick-view Function When using the LCD monitor for shooting imagesPlayback Cont’d Erasing the Playback Image Advanced Playback/Erasing Using the PLAY MenuViewing Multiple Pages at Once Index Playback Using the PLAY Menu Cont’dUsing the PLAY Menu Cont’d Copying an Imageare completed, returning you to screen Using the PLAY Menu Cont’d7. The 8-frame index appears. Using Using the PLAY Menu Cont’dErasing Unwanted Images Using the PLAY Menu Cont’dthe setting is invalidated and you 6. The 8-frame index appears. Using Using the PLAY Menu Cont’dTo select multiple images, repeat Steps 6 and Using the PLAY Menu Cont’dUsing the PLAY Menu Cont’d Adjusting LCD Monitor BrightnessUsing the PLAY Menu Cont’d Selecting/Deselecting Images to Print DPOFUsing the PLAY Menu Cont’d Using the PLAY Menu Cont’d If you chose “SELECT” or “ALL ON” Set If you chose “ALL OFF” select “YES” andUsing the PLAY Menu Cont’d Using the PLAY Menu Cont’d Reducing Image Size ResizingUsing the PLAY Menu Cont’d Setting/Canceling Protection for Your Important ImagesPressing Using the PLAY Menu Cont’dUsing the PLAY Menu Cont’d If you chose “ALL OFF” select “YES” withUsing the PLAY Menu Cont’d Moving the Image Data to Another Memory CardUsing the PLAY Menu Cont’d Using the PLAY Menu Cont’d Selecting the Set-up Menu Using the After Recording FunctionPlaying a Slide Show Using the PLAY Menu Cont’dAdvanced Operations Using the Set-up MenuFormatting a Memory Card Using the Set-up Menu Cont’dREC Menu Settings Quick View SettingsUsing the Set-up Menu Cont’d Using the Set-up Menu Cont’d Make so the Image Information is not displayedUsing the Set-up Menu Cont’d Setting the Operation SoundsAdjusting the Date and Time Setting the Self-timer Delay TimeUsing the Set-up Menu Cont’d Setting the Auto Power-OFF Time Resetting the File NumbersUsing the Set-up Menu Cont’d Setting Memory Priority Changing LanguagesUsing the Set-up Menu Cont’d Using the Set-up Menu Cont’d For the Choose-to-Record Setting “IF SELECTED”For the Always-ON Setting “ALWAYS” Taking Still Images with SoundCustomizing the camera Setting the exposure compensation to “ON”Setting the white balance switch function to “ON” Setting the AF-Lock to “ON”Using the Set-up Menu Cont’d Setting the AE-Lock to “ON”Using the Set-up Menu Cont’d Using the Set-up Menu Cont’d Restoring the Default Settings1. Windows Connecting to your PCOthers Operating EnvironmentsConnecting with a USB cable Connecting to your PC Cont’dConnecting to your PC Cont’d Downloading transferring ImagesAlways back up important data Connecting to your PC Cont’dInstalling USB Driver Software Installing software from the CD-ROM supplied8 Click “Finish” The USB device driver is now installed Installing software from the CD-ROM supplied Cont’dThe INF file necessary for the install is located in “D\” When searching a different location, click “Browse” 7 Click “Next”Using Windows Installing the included software CD-ROM and KD-500Z User’s GuideInstalling software from the CD-ROM supplied Cont’d Installing software from the CD-ROM supplied Cont’d Viewing the KD-500Z User’s GuideInstalling software from the CD-ROM supplied Cont’d Installing the Adobe Acrobat ReaderInstalling the KD-500Z User’s Guide Using MacintoshWhen Carrying the Camera Overseas Using the dedicated AC adapter kit Model No. DR-AC4Using the Attached Charger Model No. DR-BC-K4 Handling Cleaning the cameraAfter using the camera Care and StorageCare and Storage Cont’d About image dataAbout the LCD monitor Page TroubleshootingSymptom Check thisPage Troubleshooting Cont’dSymptom Check thisMain Specifications Main Specifications Cont’d 1 DCF Design rule for Camera File system is a standard by JEITA mainly for the purpose of simplifying the use of image files taken by digital cameras with other related devices Main Specifications Cont’dDuring the warranty period Warranty and After-sales ServiceWarranty separately attached When requesting serviceFCC Compliance Statement CANADA ONLY Industry Canada’s Compliance StatementThis Class B digital apparatus complies with Canadian ICES-003