Krell Industries FBI 22 RC-5In, 23 12 VDC In/Out 12 V Trigger, Back Panel Power Breaker Switch

REMOTE	22 RC-5 In
CONNECTIONS	The FBI is equipped with an RC-5 input that makes custom instal-
	lation easy and secure by accepting baseband RC-5 input com-
	mands from hardwired remote controllers.

	23 12 VDC In/Out (12 V Trigger)
	The FBI has one output that sends, and one input that receives 12 VDC
	power on/off (12 V trigger) signals to and from other Krell components,
	and other devices that incorporate a 12 V trigger. This allows you to
	turn other components on or off, or to and from stand-by. When an
	amplifier is switched to operational mode and is connected to other
	components through the 12 V trigger, it sends a signal that will switch
	other components, allowing whole systems or parts of systems to be
	easily coordinated. Mono 3.5 mm connectors are used in the following
	configuration: Tip = +12 V, Sleeve = GND.
	When the FBI is in the operational mode, the 12 V trigger provides 12 Volts
Notes
	of DC output. When the FBI is in the stand-by mode or off, the DC output
	is 0 Volts. A maximum of 30 mA is available from the 12 V trigger output.
	Consult the owner's reference of the components used in a custom instal-
	lation to take full advantage of the remote capabilities of the FBI.

POWER

CONVENIENT LIFTING DEVICE

24 Back Panel Power Breaker Switch

Place the back panel power breaker switch in the up position to put the FBI in stand-by mode. Krell recommends that the amplifier remain on, in stand-by mode, when not in use.

25 IEC Connector

The connector is for use with the provided AC power cord.

26 Handles

The FBI is equipped with two handles to help to move the inte- grated amplifier easily and safely.

Krell FBI 19