Krell Industries KCT manual Remote Control Description, Amplifier Functions

Remote Control Description

See Figure 3 on page 14

BATTERY INSTALLATION AND REMOVAL

The KCT remote control uses two AAA-size 1.5 Volt batteries. Batteries are included with the shipment. To install the batteries:

1.Remove the remote control backplate, using the supplied T-10 Torx wrench.

2.Install the batteries, following the battery position diagram on the plastic battery receptacle.

3.Replace and secure the backplate.

Replace batteries when remote control function becomes intermittent.

Remove batteries if the remote control is not used for a long period of time. Battery leakage can damage the remote control.

The remote control provides power on, input and zone selections, level and balance control, menu, and compact disc functions. Remote control keys and their descriptions follow.

Power

32 Power Key

Use this key to switch the KCT between the stand-by and the operational modes.

Amplifier Functions

33 Amp Pwr Key

Use this key to activate Krell amplifiers connected to your system. The amp pwr key also activates the control component for amplifiers connected by Krell Link.

34 Amp Sel(ect) Key

Use this key to switch between CAST and balanced inputs on a Krell Full Power Balanced amplifier connected to your system. The red center LED illuminates when the CAST output is active.

Preamplifier Functions

35 Mute Key

Use this key to mute the preamplifier output. To unmute, press the mute key again. To customize mute key operation, see Mute Menu, on page 29.

36 Phase Key

Use this key to invert the absolute polarity of the variable output 180 degrees for the selected input. The front panel display (13) shows INVERT for the negative phase; the display remains blank for the positive phase.

Krell Current Tunnel 15