Krell Industries KPS 28c QuickStart, Digital OutputConnections, Input And Outputconnec- Tions

QuickStart

Theabbreviated proceduresin this QuickStart section enableyou to connectandoperate your KPS28c systemquickly to enjoy its basic fea- tures. Toaccessthe full array of available fea- tures for the KPS28c, please read the entire owner's reference manual. Numbersin paren- thesesrefer to Figure 1 on page5, Figure 2 on page7, and Figure 3 on page9.

taneouslyin all three areas.

Digital OutputConnections

Connectthe cablesfromthe optics output (16) coaxial output (17) on the KPS28c backpanel your digital recorderor the digital input onyour preamplifier.

INPUT AND OUTPUTCONNEC- TIONS

IMPORTANT

Makesure all componentsand power sources are off before connectinginputs and outputs. Whenswitching between active sources, alwayslower the volumeto off or mutethe out- put. This ensuresthat the next source played does not damageyour systemwith a high out- put transient.

Analog Output Connections

Connectthe Krell CASTcables from the left and right Krell CAST4-pin outputs (13) on the KPS 28c back panel to your CAST-enabledpreampli- fier. For balancedor single-ended operation, connectthe interconnect cables from either the left andright balanced(14) or the single-ended

(15)outputson the KPS28c backpanel to either the balancedor the single-endedinputs on your preamplifier. (Theremainingoutputs can be con- nectedto anotherpreamplifier in a different sys- tem.)

Note

Youcan set up your KPS28c to play a musi- cal selection in three different areas. Connect the CASToutput to a CAST-enabledsystem in one listening area, the balanced output to a systemin a secondlistening area, andthe sin- gle-endedoutput to a systemin a third listen- ing area. Themusicalselection will play simul-

4

POWER ON

1.Connectthe ACpowercord to the IEC power connector (20), then connect the ACpower cord to the wall socket. TheKPS28cis in the stand-by mode. The red stand-by LED(3) illuminates.

2.Pressthe powerbutton (4) or pwr key(22) switch the KPS28c from the stand-byto the operational mode.The blue powerLED(5) illuminates and you hear a click. TheKPS 28c is readyto play music.

TO PLAY A COMPACTDISC

1.Usethe open/close button (2) or open key

(23)to openthe compactdisc transport (1).

2.Place a compactdisc on the transport.

3.Use the open/close button (2) or openkey

(23)to close the compactdisc transport (1). Playbackautomatically beginsfrom the first track. Adjust the systemvolumethroughyour preamplifieror amplifier.

4.Pressthe stop button (11) or key(28) to compactdisc playback.

Note

Youcan also begin track playback by pressing the play button(12) or key(29), or select a track using the direct track accesskeypad(26), the track forwardandbackbuttons(8, 9) or keys(30) or the searchforward andbackkeys(31).

Krell PlaybackSystem28c