OPERATION
OPERATING INSTRUCTIONS
1.Select an input with the Input switch. Notice the Signal LED will illuminate when the digital source is turned on and has linked with the Processor. Once this link is complete, the Processor is ready to pass a signal.
2.Be sure that your preamplifier volume control is turned completely to the OFF (lowest volume) position.
3.Turn ON your components, remembering that the last compo-
nent to be energized should be your amplifier. The amplifier should only be turned ON after all other components in the system have been on for at least two minutes. This will insure that no large pulse will be created when the amplifier is turned on.
4.Switch the source selector of your preamp to the position
correlating to your chosen input connection for the STUDIO2.
5.You may now start playing your digital source, DAT, CD or satellite.
6.Slowly turn the volume control up to the lowest level you can hear. Check to see that both channels are working correctly before advancing the volume.
PAGE 13
