5. ERGO Calibration Software (ERGO Cal)
5.2.1Enabling Calibration
If the Calibrate button is Off, check ERGO’s Back panel and press it (Figure 5.8). The Calibrate LED located on the Front panel will lit (green).
Figure 5.8
If the Calibrate button is already On, just click Enter. (Figure 5.9)
Figure 5.9
5.2.2Adjusting ERGO’s Volume
The next step is to adjust ERGO’s volume to a proper level, so it is adequate for the calibration process.
There are two volume adjustments. The first ensures that you have the volume set so that ERGO can hear audio. This is typically at the 10 o’clock volume position. During the second volume adjustment, ERGO measures the sound pressure from your speakers. The level is moderately loud. If you feel that the volume is too high or that your speakers may be at risk and ERGO is telling you that the volume is too low, accept the current level by following the instructions provided in the screen. ERGO will use this volume level and attempt to perform a measurement.
In the first volume adjustment the following screen will inform you whether the volume level is acceptable or requires adjustment. (Figure 5.10).
Figure 5.10
If the message displayed indicates that the volume is too low or too high, adjust the big Volume knob until you get the “Volume Ok message”, typically at 10 o’clock (Figure 5.11).
19
