20
In the second adjustment, the volume is system dependent.
55..22..33FFooccuuss PPoossiittiioonn MMeeaassuurreemmeenntt
The following window prepares you to take your Focus Position
Measurement. Before to click Enter, read the instructions below;
• Make sure that the height and orientation of the microphone
correspond to your typical listening height and direction as
illustrated below. Do not block the line of sight between the
microphone a nd the loudspeakers. Each measurement is
comprised of a low and a high frequency measuring
signal first i n the left and then in the right channel.
(Figure 5.12)
55.. EERRGGOO CCaalliibbrraattiioonn SSooffttwwaarree ((EERRGGOO CCaall))
• The length of each measurement depends on a combination
of the measurement volume, and the b ackground noise in
your local environment. Typical measuring time s for the
low and high frequency measuring s ignals are 25 and 5
seconds, respectively.
• If ERGO is unhappy with the measu rement, an error
message is displayed. Make any required corrections to your
set up and follow the prompt to retr y the measurement.
• Focus Position Measurements must be performed more than
1 m (3 ft) away from the loudspeakers, in a X/Y orientation,
and must not performed behind the loudspeaker. Also, do
not sit in the listening position while Focus m easurements
are being taken.
Now, that you’ve read and memorized the information above,
click EEnntteerrand follow the prompts to calibrate the volume level
at your focus position. (Figure 5.13)
Figure 5.11
Figure 5.12
Figure 5.13