Manuals / KTI Networks / TV and Video / TV Converter Box

KTI Networks KC-300D manual Applying Power, The AC Power Adapter Specifications

Models: KC-300D

1 21

Download 21 pages 13.03 Kb

Page 14

2.3 Applying Power

2.3 Applying Power

Before you begin the installation, check the AC voltage of your area. The AC power adapter which is used to supply the DC power for the unit should have the AC voltage matching the commercial power voltage in your area.

The AC Power Adapter Specifications

AC input power:	AC power voltage of your area, options -
	Rated AC120V/60Hz DC7.5V 1A
	Rated AC230V/50Hz DC7.5V 1A
	Rated AC100V/50-60Hz DC7.5V 1A
	Rated AC100V/50-60Hz DC5V 1A
	Rated AC240V/50Hz DC7.5V 1A

Steps to apply the power to the converters are:

1.Connect power adapter DC plug to the DC input jack located on the back of the converter before connecting to the AC outlet.

2.To ensure against accidental disconnection, tie the DC cable with the cable tie located the back of the converter.

3.Connect the power adapter to the AC outlet.

4.Check Power LED indication.

-14-

Image 14

KTI Networks KC-300D manual Applying Power, The AC Power Adapter Specifications

Contents

DOC.060215-KC-300D 10/100BASE-TX TO 100BASE-FX MEDIA CONVERTERSKC-300D Series Installation Guide United States InternationalEthernet is a registered trademark of Xerox Corp 3. Optional Configuration Settings Table of Contents2. Installation 1. Introduction1.1 Key Features 1. Introduction1.2 Specifications Twisted-Pair Interface TPPortStore-and-forward default TP Port ConfigurationAuto-negotiation default Multimode MMF - 50/125, 62.5/125 ∝ mCenter Connector LEDIndicatorsDC Power Input Optical signal is detectedEnvironmental Basic InformationMechanical CertificateSingle Fiber Bi-Di WDM Series 1.3 Optical SpecificationsDuplex Fiber Series AutoMDI/MDI-XFunction 1.4 Special FunctionsFar End Fault Function Auto-negotiation FunctionLink Fault Pass Through Function 2.2 Mounting the Device 2. Installation2.1 Unpacking 2.3 Applying Power The AC Power Adapter SpecificationsNetwork Cables 2.4 Making TP Port ConnectionConfiguration Setup Ref. distance 2.5 Making FX Port ConnectionConnector ModelSince the WDM single fiber media converters use different wavelengths for transmission and receiving respectively, the link partner device lo- cated on the remote end of the single fiber should match the wavelength used on the single fiber converter Link Fault Pass Through Function is enabled 2.6 LED IndicatorsLink Fault Pass Through Function is disabled 3. Optional Configuration Settings 3.1 User Inaccessible JumpersTP port to/from FX port 3.1.1 Forwarding Mode Setting JP1JP1 Setting Forwardmethod3.2 JP1-JP3 Factory Default Settings 3.1.2 802.3x Function Setting JP23.1.3 FX Duplex Setting JP3