Manuals / KTI Networks / TV and Video / TV Converter Box

KTI Networks KC-300D manual Making TP Port Connection, Network Cables, Configuration Setup

Models: KC-300D

1 21

Download 21 pages 13.03 Kb

Page 15

2.4 Making TP Port Connection

2.4 Making TP Port Connection

TP port is featured to support connection to :

•Auto-negotiation devices

•Auto-negotiation incapable 10BASE-T devices

•Auto-negotiation incapable 100BASE-TX devices

Network Cables
10BASE-T:	2-pair UTP Cat. 3,4,5 , EIA/TIA- 568 100-ohm STP
100BASE-TX:	2-pair UTP Cat. 5, EIA/TIA-568 100-ohm STP
Link distance:	Up to 100 meters

Configuration Setup

To make a proper connection, the following configuration settings are recommended:

TP port link partner	SW1	SW2	SW3
Auto-negotiation device	Off: auto	Off: full duplex	Off: 100M
Fixed 10M half duplex device	On: forced	On: half duplex	On: 10M
Fixed 100M half duplex device On: forced		On: half duplex	Off: 100M
Fixed 10M full duplex device	On: forced	Off: full duplex	On: 10M
Fixed 100M full duplex device On: forced		Off: full duplex	Off: 100M

-15-

Image 15

KTI Networks KC-300D manual Making TP Port Connection, Network Cables, Configuration Setup

Contents

10/100BASE-TX TO 100BASE-FX MEDIA CONVERTERS KC-300D Series Installation GuideDOC.060215-KC-300D International United StatesEthernet is a registered trademark of Xerox Corp 1. Introduction Table of Contents2. Installation 3. Optional Configuration Settings1. Introduction 1.1 Key FeaturesTwisted-Pair Interface TPPort 1.2 SpecificationsMultimode MMF - 50/125, 62.5/125 ∝ m TP Port ConfigurationAuto-negotiation default Store-and-forward defaultOptical signal is detected LEDIndicatorsDC Power Input Center ConnectorCertificate Basic InformationMechanical Environmental1.3 Optical Specifications Duplex Fiber SeriesSingle Fiber Bi-Di WDM Series Auto-negotiation Function 1.4 Special FunctionsFar End Fault Function AutoMDI/MDI-XFunctionLink Fault Pass Through Function 2. Installation 2.1 Unpacking2.2 Mounting the Device The AC Power Adapter Specifications 2.3 Applying Power2.4 Making TP Port Connection Configuration SetupNetwork Cables Model 2.5 Making FX Port ConnectionConnector Ref. distanceSince the WDM single fiber media converters use different wavelengths for transmission and receiving respectively, the link partner device lo- cated on the remote end of the single fiber should match the wavelength used on the single fiber converter 2.6 LED Indicators Link Fault Pass Through Function is disabledLink Fault Pass Through Function is enabled 3.1 User Inaccessible Jumpers 3. Optional Configuration SettingsForwardmethod 3.1.1 Forwarding Mode Setting JP1JP1 Setting TP port to/from FX port3.1.2 802.3x Function Setting JP2 3.1.3 FX Duplex Setting JP33.2 JP1-JP3 Factory Default Settings