Configuration | Description |
|
|
MAC Address | The MAC address factory configured for the switch |
| It can not be changed in any cases. |
S/W Version | The firmware version currently running |
H/W Version | The hardware version currently operating |
Active IP Address | Currently used IP address for the switch management |
Active Subnet Mask | Currently used subnet mask for IP address for the switch management |
Active Gateway | Currently used gateway IP address for the switch management |
DHCP Server | Current IP address of the DHCP server |
Lease Time Left | The time left for the lease IP address currently used |
DHCP Enabled | Use DHCP to get dynamic IP address configuration for the switch |
Fallback IP Address | IP address used when DHCP mode is not enabled |
Fallback Subnet Mask | Subnet mask for IP address used when DHCP mode is not enabled |
Fallback Gateway | Default gateway IP address used when DHCP mode is not enabled |
WDT | Enable WDT (Watch Dog Timer) |
Management VLAN | Set management VLAN information |
- VID | VLAN ID configured for web management to the switch |
- CFI | CFI value for web reply packets from the switch |
- User priority | Priority value for web reply packets from the switch |
Name * | Set the system name for this switch unit |
Password | Set new password |
SNMP enabled | Enable SNMP agent |
SNMP Trap destination | The IP address of the SNMP trap manager |
SNMP Read community | The community allowed for the SNMP [get] message |
SNMP Write community The community allowed for the SNMP [set] message | |
SNMP Trap community | The community used for the SNMP trap messages sent by the switch |
|
|
[Apply] | Click to apply the configuration change |
[Refresh] | Click to refresh current configuration |
|
|
Note:
1.It is suggested to give each switch unit a system name as an alternative unique identifica- tion beside IP address.
2.Setting change of DHCP mode takes effective in next bootup.
3.A watch dog timer (WDT) is a hardware timing device that triggers a system reset if the system firmware, due to some fault condition, such as a hang, neglects to regularly service the watch dog timer . The intention is to bring the system back from the hung state into normal operation. The timer is set to 1.72 seconds in this switch.
