Accton Technology CheetahSwitch Workgroup, 4508 manual Changing the Network Configuration

CheetahSwitch Workgroup-4508

CheetahSwitch Workgroup - 4508

Management Setup

Network Configuration ...

Serial Port Configuration ...

SNMP Configuration ...

Console Login Configuration ...

TFTP Download ...

<OK>

Use <TAB> or arrow keys to move. <Enter> to select.

Changing the Network Configuration

Use the Network Configuration menu to set the bootup option, configure the switch's Internet Protocol (IP) parameters, enable the on-board Web agent, or enable Telnet access. The screen shown below is described in the following table.

CheetahSwitch Workgroup - 4508

Network Configuration
IP Configuration ...
IP Connectivity Test (Ping) ...
Access Host Configuration ...
HTTP Configuration ...
MAX Number of Allowed Telnet Sessions (1 –4) : 4
MAC Address :	00-00-e8-12-34-56
<APPLY>	<OK>	<CANCEL>
Use <TAB> or arrow keys to move. <Enter> to select.

Parameter	Description
IP Configuration	Screen used to set the bootup option, or configure the switch’s IP
	parameters for the Ethernet interface.
IP Connectivity Test (Ping)	Screen used to test IP connectivity to a specified device.
Access Host Configuration	Screen used to restrict access to the host switch to specified subnets.
HTTP Configuration	Screen used to enable/disable the Web agent.
MAX Number of	The maximum number of Telnet sessions allowed to simultaneously
Allowed Telnet Sessions	access the SNMP agent. Up to four sessions are supported.
MAC Address	Physical address of the SNMP agent.

2-6