Accton Technology CheetahSwitch Workgroup, 4508 manual Configuring Community Names

CheetahSwitch Workgroup-4508

Configuring Community Names

The following figure and table describe how to configure the community strings authorized for trap management access. All community strings used for IP Trap Managers must be listed in this table. Up to 5 community names may be entered.

CheetahSwitch Workgroup - 4508

SNMP Configuration: SNMP Communities

	Community Name	Access	Status
1.	public	READ ONLY	ENABLED
2.	private	READ/WRITE	ENABLED
3.
4.
5.
<APPLY>	<OK>	<CANCEL>
Use <TAB> or arrow keys to move. other keys to make changes.

Parameter	Description
Community Name	A community entry authorized for trap management access. (The maximum
	string length is 20 characters).
Access	Management access is restricted to Read Only or Read/Write.
Status	Sets administrative status of entry to enabled or disabled.

Note: This switch has default community strings of “public” with read only access and “private” with read/write access.

Configuring IP Trap Managers

The following figure and table describe how to specify management stations that will receive authentication failure messages or other trap messages from the switch. Note that all community strings used for IP Trap Managers must be listed in the SNMP Communities table. Up to 5 trap managers may be entered.

CheetahSwitch Workgroup - 4508

SNMP Configuration: IP Trap Managers

IP Address		Community Name	Status
1.	10.1.0.23	public	DISABLED
2.
3.
4.
5.
<APPLY>		<OK>	<CANCEL>

Use <TAB> or arrow keys to move, other keys to make changes.

2-12