Operation
Cutting Sheet Goods
1.Adjust the hold down plate according to the width of material to be cut.
2.Lay the workpiece onto the table and up against the saw fence.
3.Slide the workpiece through the saw blade until the material engages the hold down plate. Walk the workpiece through the cut with the sliding table until the workpiece clears the saw blade and the cut is completed.
Cross Cutting
For cross cutting panels and narrow stock, position the miter fence onto the sliding table carriage as shown. Tighten lock knobs. (Fig. 24)
Making sure that table lock is disengaged, postion the workpiece against the miter fence and push sliding table through the cut.
Miter Cuts
Loosen the lock knob on the right side of the miter fence (closest to blade) slightly and use as a pivot point. Loosen the lock knob on the left side of the miter fence and position the miter fence to the desired angle using the scale on the sliding table carriage. (Fig. 25)
Figure 23
Figure 24
Figure 25
14
