Kuhn Rikon 10-110B/E Assembly, Mounting the Swing Arm Bracket, Mounting the Sliding Table

Assembly

Mounting the Swing Arm Bracket

1.Open the motor cover located at the left side of the saw.

2.With assistance hold the swing arm bracket

against the saw body and attach using four 8MM hex bolts, four 8MM washers and four 8MM hex nuts.

3.Slide the four 8MM hex bolts through the bracket and saw body and attach using the four 8 washers and four 8MM hex nuts from inside the saw body.

Figure 1.

Installing the Swing Arm Extension Bar

1.Slide the swing arm extenstion bar through the swing arm bracket making sure that the large hole is installed first and that the set screw is pointing downward. Figure 2.

Mounting the Sliding Table

1.Locate the sliding table mounting hardware which includes two knobs, two T-nuts, two 8MM washers and two adjusting plates. Figure 3.

2.Assemble the hardware as shown (Fig. 3) and slide the T-nut into the track (Fig. 4) making sure that the clamp plate is against the bottom of the table assembly.

Figure 1

Figure 2

Figure 3

Figure 4

8