USE
3) TRADITIONALBURNERS
On the surface of the hob, there is a serigraphic figure above each knob, indicating the burner to which the knob refers. After turning on the gas at the main or opening the valve on the gas bottle, light the burners as indicated below:
- automaticelectricignition
Press the knob corresponding to the burner to use and turn it clockwise to the “Maximum” position (big flame fig. 1) pressing the knob right down.
- Lighting burners fitted with a safety cut-off device
For burners fitted with a safety cutoff device, t urn the knob corresponding to the burner to use anti clockwise to the “Maximum” position (big flame fig. 1) until it stops and then press the knob. Continue pressing the knob for about 10 seconds after the burner has been lit.
Should the flames accidentally go out, turn the burner control knob off and wait at least 1 min befor attempting to light it again.
Howtousetheburners
To obtain maximum performance with minimum gas consumption, remember the following:
use suitable pans for each burner (see the table below and fig. 2).
When boiling point is reached, turn the knob to th e “Minimum” position (small flame fig. 1).
Always use pans with lids. “DUAL” burner:
separate regulation of the inner and outer rings (in practical terms, a dual burner controlled by a single knob), offering very flexible use thanks to the possibility to light either the inner flame only or the whole burner (inner and outer flame at the same time).
LIGHTINGANDUSINGTHE“DUAL”BURNER Standthepanontheburnerbeforelighting. Despite being controlled by a single knob, the “DUAL”burner can be used in two different ways.
A) Using the complete burner:
Starting from the off position ● You must first press the knob, simultaneously turning it anticlockwise,
until the indicator points to the maximum delivery | |
position | obtaining the maximum flow capacity of |
both flames. |
|
When the flames are lit, keep the knob pressed for | |
a few seconds, until the device automatically keeps | |
the burner lit. | |
It is now possible to regulate the intensity of the | |
flame by turning the knob anticlockwise (from the | |
maximum flow capacity position of the inner and | |
outer flames to the maximum flow capacity of the | |
inner flame and the minimum of the outer flame. | |
To turn off the burner, turn the knob clockwise, | |
realigning the indicator with the ● off symbol. | |
B) Using the inner flame only:
after lighting the burner and regulating the inner flame to maximum flow capacity and the outer flame to minimum flow capacity as described above, turn the knob anticlockwise until it clicks once. The inner flame is now at maximum flow capacity while the outer flame is turned off.
Continue turning anticlockwise to regulate the inn er flame to the minimum flow capacity.
Turning off:
to turn off the burner, turn the knob clockwise, realigning the indicator with the ●off symbol.
Once the “DUAL” burner is operating in either of the two modes described, it is possible to swap from one mode to the other by simply pressing and turning the knob to the position required:
5
