INSTALLATION
6) FITTING THE HOB
The hob is equipped with a special seal to avoid any infiltration of liquid into the unit. To apply this seal correctly, please follow the instructions given below carefully:
remove all the mobile parts of the hob.
Cut the seal into 4 strips of the lengths suitable to fit it along the 4 sides of the glass.
Turn the hob upside down and place the adhesive side of the seal “E” (fig. 8) correctly under the edge of the hob so that the outer edge of the seal perfectly matches the outer perimeter edge of the glass. The ends of the strips must match without overlapping.
Stick the seal to the glass evenly and securely, using your fingers to press it into place.
In order to avoid accidental contact with the surface of the box of the overheated hob during use, it is necessary to install a wooden divider at a minimum distance of 150 mm from the top, fastening it in place with screws. (fig. 6).
To fasten this product to the supporting structure, we advise you not to use mechanical or electrical screwdrivers and to exercise moderate pressure by hand on the fastening hooks.
FIG. 8
FIG. 9
10
