USE

2) BURNERS

A diagram is screenprinted above each knob on the front panel. This diagram indicates to which burner the knob in question corresponds. After having opened the gas mains or gas bottle tap, light the burners as described below:

- manualignition

Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the full on position (large flame fig. 1), then place a lighted match near the burner.

- Electricalignition

Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the full on position (large flame fig. 1), then depress and release the ignition button “E”.

- Automaticelectricalignition

Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the full on position (large flame fig. 1), then depress the knob.

- Lighting burners equipped with flame failure device

The knobs of burners equipped with flame failure device must be turned in an anticlockwise direction until they reach the full on position (large flame fig. 1) and come to a stop. Now depress the knob in question and repeat the previously indicated operations.

Keep the knob depressed for about 10 seconds once the burner has ignited.

HOWTOUSETHEBURNERS

Bear in mind the following indications in order to achieve maximum efficiency with the least possible gas consumption:

use adequate pans for each burner (consult the following table and fig. 2).

When the pan comes to the boil, set the knob to the reduced rate position (small flame fig. 1). Always place a lid on the pans.

Use only pan with a flat bottom.

 

 

 

Burners

PowerratingsBTU

PanØincm

“DUAL”burnertotal

13000÷14500Btu/h

24 ÷ 26

simmer

2550÷3200Btu/h

 

Fast burner

8350Btu/h

20 ÷ 22

Semifastburnerfront

4350Btu/h

16 ÷ 18

Semifastburnerback

4350Btu/h

16 ÷ 18

Auxiliary

3400Btu/h

10 ÷ 14

WARNINGS:

- burners with flame failure device may only be ignited when the relative knob has been set to the Fullonposition(largeflamefig.1).

- Matches can be used to ignite the burners in a blackout.

- Never leave the appliance unattended when the burners are being used. Make sure there are no children in the near vicinity. Particularly make sure that the pan handles are correctly positioned and keep a chek on foods requiring oil and grease to cook since these products can easily catchfire.

- The machine must not be used by people (including children) with impaired mental or physical capacities, or without experience of using electrical devices, unless supervised or instructed by an expert adult responsible for their care and safety. Children should not be allowed toplaywiththeequipment.

- Never use aerosols near the appliance when it is operating.

- If the built-in hot plate has a lid, any spilt food shouldbeimmediatelyremovedfromthisbeforeit is opened. If the appliance has a glass lid, this could shatter when the hot plate becomes hot. Always switch off all the burners before closing thelid.

- Containers wider than the unit are recommended.

FIG. 1

FIG. 2

4

Page 4
Image 4
Kuppersbusch USA GKS9751.0 M-UL, GKS 6740.0 M-UL, GKS 3720.0 M-UL manual Use, Burners