INSTALLATION REQUIREMENTS

2.3.3.4GPS/IMU Connectivity

Cabling consisting of six (6) wires will need to run from the V750 to the GPS/IMU.

It is possible to use existing wires to avoid running new wires by creating an extension with a DB9 connector on each end of the wires. Otherwise the cable from the GPS/IMU will be run from the roof down to the V750 where it will connect to the harness.

+12VDC power is provided by the V750

2.3.3.5EVDO/3G Router Connectivity

Requires EVDO/3G PCMIA Card with service activated (provided by customer on their service plan).

Requires 120VDC

Requires one CAT5 cable

2.3.4IP Connectivity

In order for VanLink to work remotely from the studio, the MC-17s and TNS (if equipped with Controll2_TNS1 software) must have access to the internet (WAN). Most studios have a unique configuration as well as their own unique security measures and policies which must be discussed and necessary preparations should be coordinated with their own respective IT departments. The minimum open port requirements for the master controller(s) running TouchStar to establish communications with the V750 inside the vehicles running VanLink are as follows:

2.3.4.1Master Controller(s) and TNS Accessibility

Master Controller(s) and TNS (if equipped with Controll2_TNS1 software) must have access to the outside internet (see Figure 2–3).

Open ports required are: 80, 2000, 2009, 2050, and 2099

Port 80* (TCP/IP) is the HTTP port required for the MC-17 or TNS to resolve Dynamic DNS IP addresses.

Port 2000 (TCP/IP & UDP) is for terminal access (TELNET) for remote configuration of the V750 primarily via the Forge application

Port 2009 (UDP) is the port TouchStar uses to communicate with the program running at the V750

Port 2050 (TCP/IP) is the port used also used for terminal access for applications other than Forge

Port 2099 (TCP/IP & UDP) is another port being utilized by Forge for remote configuration

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08

VanLink System Requirements 2-5

Page 27
Image 27
Kyocera VLSG-01 manual IP Connectivity, 3.4 GPS/IMU Connectivity, EVDO/3G Router Connectivity