Manuals / Kyocera / Computer Equipment / Network Router

Kyocera VLSG-01 manual C100 User Interface

Models: VLSG-01

1 41

Page 4

Master Controller Software Requirements	1-4
Introduction	2-1
Safety Recommendations	2-1
Installation Requirements	2-2
Power Requirements	2-2
Rack Installation	2-2
Rack Space Requirements	2-2
Cable Requirements	2-2
Running Cables	2-3
V750 Cable and Connector Requirements	2-3
Pan and Tilt Cabling and Connector Requirements	2-4
GPS/IMU Connectivity	2-5
EVDO/3G Router Connectivity	2-5
IP Connectivity	2-5
Master Controller(s) and TNS Accessibility	2-5
Typical Network Configuration for VanLink	2-7
GPS/IMU Mounting Considerations	2-7
GPS/IMU Assembly	2-7
GPS/IMU Mounting Considerations	2-7
VanLink GPS	2-8
Calibration	2-9
Magnetometer Calibration	2-9
Antenna Calibration	2-9
Remote and Local Control	2-9
Operating Requirements	2-10
Transmitter Control / Available Options	2-10
Introduction	3-1

C100 User Interface -2

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 1/11/2007

Page 4

Image 4

Kyocera VLSG-01 manual C100 User Interface

Contents

VanLink System Installation Guide Troll Systems Corporation Ground-BasedProductsTroll Systems Corporation Technical Publications Document VLSG-01Revision - 10/17/2008Troll Systems Corporation 24950 Anza Avenue Valencia, CA 91355, U.S.A2008 Troll Systems Corporation NOTICETable of Contents C100 User Interface Safety Considerations INTRODUCTIONSUMMARY VANLINK EQUIPMENT COMPONENTSABBREVIATIONS, ACRONYMS, TERMS INTRODUCTIONTerm DefinitionABBREVIATIONS, ACRONYMS, TERMS TermDefinition Introduction P-3PACKAGING WARRANTYINTRODUCTION CONVENTIONS USED IN THIS DOCUMENT WARNINGS, CAUTIONS, NOTES, AND HINTSVanLink Component Set-upand Operation WarningsCautions HintsHint This format is used for all hints INTRODUCTIONCONTACT INFORMATION CONTACT INFORMATIONINTRODUCTION SAFETY CONSIDERATIONS GENERAL SAFETY PRECAUTIONSDo Not Service or Adjust Alone Hazard Advisory Placards/SignsVanLink Safety Considerations Electrical Power/Shock HazardsBe Familiar With Resuscitation Techniques Coincidental Damage to Equipment in CabinetsLifting/Handling Hazards Safety Considerations S-3Electrostatic Discharge Sensitive ESDS Components Safety Considerations S-5 Page SECTION VANLINK SYSTEM OVERVIEW 1.1SYSTEM OVERVIEWLocal and Remote Controller COMM 12 wire Nycoil from V750 to Tx Antenna COMM1.1.1VanLink System Features Figure 1-2.VanLink IMU ConfigurationSYSTEM OVERVIEW GPS MagnetometerFigure 1-3.VanLink Remote Studio Configuration Switcher / RouterSYSTEM OVERVIEW Document VLSG-01- 10/21/081.2SPECIFICATIONS SPECIFICATIONS1.2.1Required System Components 1.2.1.1Hardware Requirements2.2SAFETY RECOMMENDATIONS SECTION VANLINK SYSTEM REQUIREMENTS2.1INTRODUCTION VANLINK SYSTEM GUIDE2.3INSTALLATION REQUIREMENTS 2.3.1Power Requirements2.3.2Rack Installation INSTALLATION REQUIREMENTSINSTALLATION REQUIREMENTS 2.3.3.1Running Cables 2.3.3.2V750 Cable and Connector RequirementsFigure 2-1.Cable Connector/Adapters E-201-0101-01 Refer to FigureFigure 2–2.Typical Network Configuration INSTALLATION REQUIREMENTS2.3.4.1Master Controllers and TNS Accessibility 2.3.4IP Connectivity2.3.3.4GPS/IMU Connectivity 2.3.3.5EVDO/3G Router ConnectivityFigure 2–3.Typical VanLink Network Configuration INSTALLATION REQUIREMENTSDocument VLSG-01- 10/21/08 Troll Systems2.4GPS/IMU ASSEMBLY 2.3.5Typical Network Configuration for VanLinkGPS/IMU ASSEMBLY 2.4.1GPS/IMU Mounting ConsiderationsGPS/IMU ASSEMBLY Figure 2-4.GPS/IMU Assembly 2.4.2VanLink GPS2.5CALIBRATION 2.6REMOTE AND LOCAL CONTROL2.5.1Magnetometer Calibration 2.5.2Antenna Calibration2.7.1Transmitter Control / Available Options 2.7OPERATING REQUIREMENTSOPERATING REQUIREMENTS SECTION ENGINEERING DRAWINGS 3.1INTRODUCTIONVANLINK SYSTEM GUIDE Document VLSG-01- 10/21/08Page Page Page Page Page Page