Kyocera VLSG-01 2.3INSTALLATION REQUIREMENTS, 2.3.1Power Requirements, 2.3.2Rack Installation

INSTALLATION REQUIREMENTS

2.3INSTALLATION REQUIREMENTS

The Vanlink System components install easily in a standard 19-inch equipment rack. Physical characteristics of the Vanlink System components are provided in the applicable assembly drawings. Both standard and custom rack installations must meet these dimensional requirements in order to properly accommodate the installation of the controller.

2.3.1Power Requirements

Power provided at the vehicle must meet either of the following requirements:

•120VDC for the V750 Remote Site Controller

•120VDC for the Router

•120VDC for the V750 Pan and Tilt Controller

2.3.2Rack Installation

Vanlink System components rack space requirements are as follows:

2.3.2.1Rack Space Requirements

•V750 – Requires two rack spaces

•Pan/Tilt controller – Requires two rack spaces unless otherwise specified

•EVDO/3G Router – One rack space (not necessarily rack mounted)

2.3.3Cable Requirements

All applicable cables may be able to be installed (with the ready connectors) after installing the Vanlink System components into the equipment rack. Connectors and cables may vary depending upon each customer’s installation requirements.

Cables may be fabricated in the factory. In some cases, customers may choose to fabricate the cables themselves to custom lengths for the best possible configuration or fit within their equipment rack. It is recommended to refer to the System Interconnect Diagram that will accompany your system to determine the cable requirements for your system.

User Manual 2-2

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08