Manuals / Kyocera / Computer Equipment / Network Router

Kyocera VLSG-01 manual 3.VanLink Remote Studio Configuration, System Overview, Switcher / Router

Models: VLSG-01

1 41

Download 41 pages 10.3 Kb

Page 21

Image 21

SYSTEM OVERVIEW

1.1.1.1Remote Control from the Studio or Control Center

Comprehensive remote control of ancillary vehicle functions including pan and tilt, vehicle tracking and signal optimization. (see Figure 1–3).

Troll Systems MC17 Master Controller with GUI Page / Map

Switcher / Router

WAN

Figure 1–3. VanLink Remote Studio Configuration

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08

VanLink System Overview 1-3

Page 21

Image 21

Kyocera manual 3.VanLink Remote Studio Configuration, System Overview, Switcher / Router, Document VLSG-01- 10/21/08

Contents

Troll Systems Corporation Ground-BasedProducts VanLink System Installation GuideTroll Systems Corporation Technical Publications Document VLSG-01Revision - 10/17/2008Valencia, CA 91355, U.S.A Troll Systems Corporation 24950 Anza Avenue2008 Troll Systems Corporation NOTICETable of Contents C100 User Interface INTRODUCTION Safety ConsiderationsSUMMARY VANLINK EQUIPMENT COMPONENTSINTRODUCTION ABBREVIATIONS, ACRONYMS, TERMSTerm DefinitionTerm ABBREVIATIONS, ACRONYMS, TERMSDefinition Introduction P-3WARRANTY PACKAGINGINTRODUCTION WARNINGS, CAUTIONS, NOTES, AND HINTS CONVENTIONS USED IN THIS DOCUMENTVanLink Component Set-upand Operation WarningsHints CautionsHint This format is used for all hints INTRODUCTIONCONTACT INFORMATION CONTACT INFORMATIONINTRODUCTION GENERAL SAFETY PRECAUTIONS SAFETY CONSIDERATIONSDo Not Service or Adjust Alone Hazard Advisory Placards/SignsElectrical Power/Shock Hazards VanLink Safety ConsiderationsCoincidental Damage to Equipment in Cabinets Be Familiar With Resuscitation TechniquesLifting/Handling Hazards Safety Considerations S-3Electrostatic Discharge Sensitive ESDS Components Safety Considerations S-5 Page 1.1SYSTEM OVERVIEW SECTION VANLINK SYSTEM OVERVIEWLocal and Remote Controller COMM 12 wire Nycoil from V750 to Tx Antenna COMMFigure 1-2.VanLink IMU Configuration 1.1.1VanLink System FeaturesSYSTEM OVERVIEW GPS MagnetometerSwitcher / Router Figure 1-3.VanLink Remote Studio ConfigurationSYSTEM OVERVIEW Document VLSG-01- 10/21/08SPECIFICATIONS 1.2SPECIFICATIONS1.2.1Required System Components 1.2.1.1Hardware RequirementsSECTION VANLINK SYSTEM REQUIREMENTS 2.2SAFETY RECOMMENDATIONS2.1INTRODUCTION VANLINK SYSTEM GUIDE2.3.1Power Requirements 2.3INSTALLATION REQUIREMENTS2.3.2Rack Installation INSTALLATION REQUIREMENTS2.3.3.2V750 Cable and Connector Requirements INSTALLATION REQUIREMENTS 2.3.3.1Running CablesFigure 2-1.Cable Connector/Adapters E-201-0101-01 Refer to FigureINSTALLATION REQUIREMENTS Figure 2–2.Typical Network Configuration2.3.4IP Connectivity 2.3.4.1Master Controllers and TNS Accessibility2.3.3.4GPS/IMU Connectivity 2.3.3.5EVDO/3G Router ConnectivityINSTALLATION REQUIREMENTS Figure 2–3.Typical VanLink Network ConfigurationDocument VLSG-01- 10/21/08 Troll Systems2.3.5Typical Network Configuration for VanLink 2.4GPS/IMU ASSEMBLYGPS/IMU ASSEMBLY 2.4.1GPS/IMU Mounting Considerations2.4.2VanLink GPS GPS/IMU ASSEMBLY Figure 2-4.GPS/IMU Assembly2.6REMOTE AND LOCAL CONTROL 2.5CALIBRATION2.5.1Magnetometer Calibration 2.5.2Antenna Calibration2.7OPERATING REQUIREMENTS 2.7.1Transmitter Control / Available OptionsOPERATING REQUIREMENTS 3.1INTRODUCTION SECTION ENGINEERING DRAWINGSVANLINK SYSTEM GUIDE Document VLSG-01- 10/21/08Page Page Page Page Page Page