The seconds are automatically set to zero.
-The WWVB reception can also be switched on or off by means of the “WWVB” touch screen field as long as the time is flashing (radio mast symbol on or off respectively).
-In addition, it now possible to select the display format for the time, date and day of the week between military and standard format using the “12/24h” touch screen field.
-When all the settings have been made, you can exit
Please note:
Reception of the WWVB time transmission signal is possible within a radius of approx. 2000 miles of Ft. Collins, Co. Outside this range, the clock is set manually and runs as an equally precise quartz clock.
Setting the day and the date
The date and the day of the week are displayed in touch screen field 21.
-Touch screen field 21 must be pressed in order to make the required settings.
-The date display will now flash:
German (24 h): | or English (12 h). |
and the lower touch screen field will change to the following form:
-The date can now be set using the touch screen fields “+” and
-The day of the week can also be selected using touch screen field 27 (DAY) as long as the date is flashing.
-In addition, it now possible to select the display format for the time, date and day of the week between military and standard format using the “12/24h” touch screen field.
Please note: The whole of the display changes each time, i.e. the time, date format and language for the day of the week display.
-When all the settings have been made, you can exit
Sensor administration
Sensor administration is called up by pressing the “SENSOR ADMIN” touch screen field:
4
1 2 
3
Here you can set the following parameters:
-Address for the rain (1), wind (2) and brightness sensors (3) if deviating from address 7. If an address is changed here, after leaving the configuration mode, the weather station will carry out a complete sensor synchronization for 6 minutes (as at 7:30 in the morning).
-Sensor protocol version (4).
1.Sensor addresses
The sensor addresses can be set up by touching the associated field (0 to 7).
2.Protocol version
The sensor protocol version can be changed over between 1.1 and 1.2 by touching the “Version” field (field 1)(for an explanation see section on Commissioning, page 6).
14
