Chapter 3: Configuration and management LANCOM Reference Manual LCOS 3.50
19
Configuration and manage-
ment
Secure with HTTPS
WEBconfig offers an encrypted transmission of the configuration data for
secure (remote) management via HTTPS.
https://<IP address or device name>
For maximum security, please ensure to have installed the latest ver-
sion of your Internet browser. For Windows 2000, LANCOM Systems
recommends to use the “High Encryption Pack” or at least Internet
Explorer 5.5 with Service Pack 2 or above.
3.2.3 Configuration using Telnet
Start configuration using Telnet, e.g. from the Windows command line with
the command:
C:\>telnet 10.0.0.1
Telnet will then establish a connection with the device using the IP address.
After entering the password (if you have set one to protect the configuration),
all configuration commands are available.
Change the language of the display.
The terminal can be set to English and German modes. The display language
of your LANCOM is set to English at the factory. In the remaining documen-
tation, all configuration commands will be provided in English. To change the
display language to German, use the following commands:
TFTP
Certain functions cannot be run at all, or not satisfactorily, with Telnet. These
include all functions in which entire files are transferred, for example the
uploading of firmware or the saving and restoration of configuration data. In
this case TFTP is used.
TFTP is available by default under the Windows 2000 and Windows NT oper-
ating systems. It permits the simple transfer of files with other devices across
the network.
Configuration tool Run (when English is the selected language)
WEBconfig Expert configuration Setup Config-module Language
Telnet
set /Setup/Config module/Language German