Land Pride 313-308M manual Pre-Assembly Checklist, Sling Bracket, Tire Track Remover Assembly

Table of Contents

Section 1: Assembly & Set-Up (Standard)

Pre-Assembly Checklist

Check	Reference
All major frame components	Operator’s
	Manual
Fasteners and pins that were shipped	Operator’s
with the seeder.	Manual
NOTE: All hardware from the factory
has been installed in the location where
it will be used. If a part or fastener is
temporarily removed for assembly
reasons, remember where it goes.Keep
the parts separated.
All working parts are moving freely,	Operator’s
bolts are tight and cotter pins are	Manual
spread.
If a pin, bolt or other part has been	Operator’s
removed, and you are unsure where it	Manual
is used, refer to the parts manual. Be
sure the part gets used in the correct
location. By double checking while you
assemble, you will lessen the chance of
using a bolt incorrectly that may be
needed later.
All grease fittings are in place and	Section 4
lubricated.	Page 25
Proper tension and alignment on all	Operator’s
drive chains.	Manual
Safety decals are correctly located and	Important
legible. Replace if damaged.	Safety
	Information

Sling Bracket

Refer to Figure 1-1

The sling brackets allow points at each end to hook the chain for lifting of the unit. When hooking the chain to the sling brackets, be certain to either use a spreader bar on the chain or use a long chain to prevent bending the sling brackets.

Sling Bracket

Figure 1-1

Tire Track Remover Assembly

For shipping purposes the Tire Track Removers are assembled 180 degrees from their operating position.

Refer to Figure 1-2

1.Remove Track Remover (#1).

2.Flip Track Remover over 180 degrees and reassemble as shown with 1/2” u-bolt (#4), lockwasher (#3) and nut (#2).

20589

Tire Track Remover

Figure 1-2

8 PS2096 Series Primary Seeders 313-308M 4/03/08