ASSEMBLY
Following these steps in order will minimize the build time and ensure proper assembly.
1.Install the Back Leg
A.
Have one person lift up the rear of the bike frame and hold
B.
While rear of the bike frame is suspended in the air, assemble rear leg assembly with:
∙(2) M10x1.5, 55mm Flat Head Screw
∙(2) 10mm Washer, Flat
∙5mm Hex Wrench
∙
Tighten all screws and securely using a torque wrench to 85 Inch Pounds
2.Install the Handlebar
A.
Insert pop
B.
Slide the handlebar post into the frame making sure the holes face the front of the bike.
Allow the post to go into the frame all the way in to level 1 and align the pop pin so it snaps into the hole then tighten the pop pin and test for steadiness.
Loosen the pop pin and raise the handlebar to its highest position and tighten the pop pin and test for steadiness.
3.Install the Front Leg
A.
Have one person lift up the rear of the bike frame and hold
B.
While rear of the bike frame is suspended in the air, assemble front leg (with wheels facing away from the frame) with:
∙(2) M10x1.5, 55mm Flat Head Screw
∙(2) 10mm Washer, Flat
∙5mm Hex Wrench
∙
Tighten all screws/nuts securely using a torque wrench to 85
Move the bike to a flat surface and adjust the four leveling feet so the bike is stable.
Step 1A | Step1B |
Step 2A | Step 2B |
Step 3A | Step 3B |
Page 13 | SPINNER® OWNER’S GUIDE |