Land Pride | Table of Contents |
Section 2: Assembly &
Pull Tongue Hook-Up
Refer to Figure 1-9:
The lower link handles should be in the down position before preceding.
1.Mount Pull Tongue to tractor drawbar and secure with safety chain.
2.Connect hydraulic hoses to tractor.
3.Fully extend the lift cylinder to rase the transport wheels and lower the hitch links.
4.Back the pull tongue up to the seeder to align the hitch links with the seeder’s inside smaller pins.
5.Retract the lift cylinder to rase the hitch links up around the seeder’s inside smaller pins until the pins lock into the lower hitch links. Once the pins are locked in, adjust the lift cylinder up or down as needed to level the seeder.
6.With the seeder level and the transport wheels resting on the ground, adjust the top center link of the pull tongue so that it will install in the bottom holes of the seeder’s upper center hitch. (Top center link pin is provided by the customer)
Locking Release
Handles
Top Center Link
Pull Tongue Disconnect
!CAUTION
The seeder will have negative tongue weight when it is lifted off the ground. Lower the seeder to the ground before proceeding with Pull Tongue disconnect. (Negative tongue weight is when most of the weight is to the rear of the implement causing the front of the tongue to be light and may rise up when disconnected.)
1.Remove top link pin.
2.Flip locking release handles up on pull tongue.
3.Lower tongue until the links are free from the seeders lower pins.
Bottom Holes of
Upper Center
Hitch
Inside Smaller
Pins
Lift Cylinder |
| Hitch Link |
|
|
|
20740
Pull Tongue Assembly
Figure
4/03/08 | PS2096 Series Primary Seeders | 13 |
