Table of Contents
Section 1: Assembly and Set-Up
Land Pride
Tractor Requirements
The RCR15 Series Rotary Cutters are designed for use with tractors that are equipped with a (540 RPM 1
The tractor must also provide for
NOTE: In order to maintain steering control, ballast may need to be added to your tractor. To determine whether or not to add the ballast, refer to your tractor’s operator manual.
Refer to Figure 1-1:
4.The
5.The rear braces (#3) are rotated back and are strapped to the gauge wheel mainframe. Undo the rear braces from the gauge wheel mainframe and rotate the braces up as shown. The rear braces (#3) should be to the the outside of the front
6.Place the top hitch spacer (#6) in the upper hitch (#4) and between the front
7.Secure with the 5/8” x 5” long bolt and 5/8” lock nut.
Dealer Assembly
NOTE: Do not tighten hardware until assembly is complete. Refer to “Torque Values Chart” on page 24.
Dealer Assembly
Figure | 16374 |
|
8 | RCR1542, RCR1548, RCR1560 and RCR1572 Rotary Cutters | 12/28/05 |