Making Printer Settings Using the Control Panel
143
❒Spooling stores a sent print job temporarily in the printer, and then prints it.
❒This menu appears only when the optional hard disk is installed.
❖Letterhead Mode
You can select the letterhead printing mode.
•Off
• Auto Detect
• On (Always)
❒Default: Off
❖Bypass Priority
When the different paper size or type is specified from the driver, you can
specify which setting is given priority to, machine setting or command.
• Machine
• Driver/Command
❒Default: Driver/Command
❖RAM Disk
If the optional hard disk is not installed for PDF Direct Print, select a value of
2 MB or higher.
This menu appears only when the optional hard disk is not installed.
• 0 MB
• 2 MB
• 4 MB
• 8 MB
•16 MB
❒Default: 4 MB
❒When the amount of SDRAM is small and RAM Disk is set to 16 MB, print-
ing may not be possible depending on the print job and duplex printing may
be canceled. If this happens, increase the amount of SDRAM, or set RAM
Disk to 8 MB or less.
For details about the optional SDRAM module, see Setup Guide.
❖Notify by Email
You can specify whether or not to send an error message to a preset e-mail
address when an error occurs in the printer.