Installing Options
55
Attaching Memory Unit Type D 128MB, Memory Unit Type E 256MB (SDRAM Module)
❒Before touching the memory unit, ground yourself by touching something met-
al to discharge any static electricity. Static electricity can damage the memory
unit.
❒Do not subject the memory unit to physical shocks.
❒Available memory varies depending on model type.
❒Before using the new memory unit, you must make settings in the printer driv-
er.
ATurn off the power, and then unplug the power cable.
BRemove the two screws securing the controller board to the back of the
printer.
❒These screws will be used again in step K to secure the controller board.
•Do not touch the inside of the controller board compartment. Doing so may
cause a malfunction or a burn.