f e a t u r e s a n d s p e c i f i c a t i o n s
11.Rear Channel Output Terminals
12.Subwoofer Output Terminals
13.Subwoofer Level Remote Control This terminal may be used to connect the Remote Subwoofer Level Control. This enables Terminal the user to have easy access to adjust the bass levels to compensate for increased road
noise or recording variations.
14.Power Indicator This indicator lights up when the internal power supply is activated and the unit is operational.
15.Front Inputs To be connected to the Front outputs of the head unit. Make sure the Dual Input Switch is in the “4CH” position.
16.Rear Inputs To be connected to the Rear outputs of the head unit. If your head unit has only one set of outputs connect them to the Rear set of inputs.
17.Dual Inputs/Outputs When used as inputs, these terminals are connected to the sub out of the source unit. When used as outputs these terminals are connected to the Rear channel inputs of another electronic crossover in a
18.Dual SUB IN & F/R MIX Switch When this switch is in the “F/R MIX” position, the stereo sum of the front and rear input signals is routed to the Dual In/Out terminals. This summed signal can then be used by the subwoofer channel or become output to another electronic crossover. In the “SUB IN” position the Dual In/Out terminals become the input terminals for the subwoofer channel.
Crossover Frequencies |
|
|
1.6K - 8KHz |
| |
40Hz - 240Hz |
| |
1.6KHZ - 8KHz |
| |
| 1.6KHZ - 8KHz |
|
40Hz - 240Hz |
| |
1.6KHZ - 8KHz |
| |
Crossover Slope Rate | 12dB per octave |
|
Subwoofer Boost | Single octave 0dB - 12 dB | 6 |
Boost Frequency | at 40 - 120Hz (variable) |
|
Mid Cut |
| |
Mid Cut Q: | 1, 3, 6 |
|
Distortion | 0.01% THD at 1 volt output |
|
Frequency Response | 10Hz - 30KHz ±3 dB |
|
95dB |
| |
Separation | 60dB |
|
Power Source | 14.4 Volts DC |
|
| Negative ground |
|
Dimensions | ||
| (245 x 270m x 38mm) |
|
