ATX6 Installation and User Guide
Page 8
4 Hours (00 ~ 12 AM/PM)
Use the INC button to advance through the values. Advancing past ‘11’
will also toggle the AM and PM indicators. Press the SET button when
the correct value is displayed.
5 Minutes (00 ~ 59)
Use the INC button to change the value of the first digit. Use the NXT
button to move the cursor to the next digit, and then use the INC
button to change the selected digit. Press the SET button when the
correct value is displayed.
Press SET after this step to set seconds to :00. For the most precise
manual time setting, increment the displayed value to represent the
up-coming minute. Then, at the start of the new minute, press the SET
button to record the programmed MM-DD-YY HH:MM:00.
Parameter Set-Up:
To enter the Parameter Set-Up Mode, simultaneously press the Left
(INC) and Center (NXT) buttons for 1 second. You will see the Password
prompt: “P000”. For each of the following parameters to be set, the
display will show the parameter number in the two left digit positions,
and the parameter value in the two right digit positions. The
parameters are as follows:
P Awaiting Password (000 ~ 999)
If you have not previously changed the password, press the SET button
to continue [Default Password is ‘000’]. If you have previously changed
the Password, enter the value using the INC, NXT and SET buttons. The
INC button will increment the digit over the displayed cursor. The NXT
button will move the cursor to point to the next digit. The SET button
will enter your final selection. If correct, the display will advance to
enter the first set-up parameter.
If incorrect, an “Err” message will be displayed. Press the Set button
to re-enter your password. Press Inc or Next to abort the setup.