Lathem manual PC400TX TCP/IP Connections optional, To make a TCP/IP connection

10 - PC400 Terminal Installation & User’s Guide

PC400TX TCP/IP Connections (optional)

For Ethernet communications, CAT 4 or 5 unshielded twisted pair high-speed data communication cable is recommended. A standard Ethernet cable should be used, unlock and remove the terminal from the mounting bracket. Route the cable through the desired knockout of the mounting plate and plug the RJ45 plug into the Ethernet Communication port as shown below

See Appendix D for the directions on installing a 10Base T module in the field.

To make a TCP/IP connection

♦Connect a standard Ethernet cable to the network switch.

♦Insert the other end of the standard Ethernet cable through a knockout in the terminal back box and plug it into the clock’s Modem/10 Base T connection port as shown in the diagram below, Figure 5.

Modem /

10 Base T

Connection

Port

Figure 5