INSTALLATION
MANUFACTURED (MOBILE) HOME INSTALLATION
Model
In addition to the standard installation instructions, the following instructions may be required by local, state or federal building codes:
•Stove must be permanently bolted to the floor.
•An outside air inlet must be provided for combustion and be unrestricted while unit is in use.
•Stove must be permanently electrically grounded to the steel chassis of the home. The location selected for ground attachment to the stove must be dedicated for this purpose.
•See pages 10 through 15 for additional information on venting requirements.
•Do not install appliance in a sleeping room.
•The structural integrity of the manufactured home floor, walls, ceiling and roof must be maintained.
NOTE: The grounding of this product, at installation, must comply with
Model - T300P SERIES
Chassis
Floor
Bolt Floor
Protector
MANUFACTURED (MOBILE) HOME EXHAUST VENT PIPE INSTALLATION GUIDELINES
Use only listed type “PL” pellet vent pipe. Pipe should extend at least 3 feet above the part of the roof through which it passes. The top of the pipe should be at least 2 feet above the highest required elevation of any part of the manufactured (mobile) home within 10 feet of the pipe.
If the exhaust vent exits the manufactured (mobile) home at a location other than the roof, and exits at a point 7 feet or less above the ground level on which the manufactured (mobile) home is position a guard or method of enclosing the pipe shall be provided at the point of exit for a height of up to 7 feet. The openings, if any, in this guard shall not allow a 3/4” rod to pass through. A 1/2” rod could pass through but should not be able to touch the pipe when inserted through the opening a distance of 4 inches.
Page 7
REMOVING APPLIANCE FROM PALLET
1.After removing the packaging from the stove, lift the hopper lid, and remove all
2.Remove screws which secure legs to pallet.
INSTALLING LEG LEVELING BOLTS
The four leg leveling bolts (included in accessory pack- age), are provided for leveling the stove if necessary. To install, thread the bolts into the existing holes in the bottom of each leg. Turn the leveling bolts to adjust for correct height.
INSTALLATION CHECK LIST
It is strongly recommended that you have an authorized Lennox Hearth Products dealer install your stove. If you install your stove yourself, you should review your in- stallation plan with your authorized Lennox Hearth Products dealer.
Check list:
Check off each item as you proceed with the installation process.
Read the ENTIRE stove installation section first. Determine the appropriate measurements and loca- tions for your installation.
Follow the general installation directions under Stove Installation and the installation section ap- propriate to your stove.
Be sure to
Prior to lighting your stove:
Review the safety precaution section. Review the pellet fuels section.
Review and follow the Operating Instructions.
Plug power cord connector into corresponding con- nector on the back of appliance (see illustration on page 9 showing connector locations).
After you have begun operation of your stove: Review the routine cleaning / maintenance informa- tion.
Enjoy the warmth from your new Lennox Hearth Products pellet stove!
