Lenovo G230 UG V1.0_en.book Page 27 Monday, July 28, 2008 7:29 PM

Chapter 2. Using Your Computer

Changing or Removing the Supervisor Password

To change the password, do the following:

1Select Set Supervisor Password, and press the Enter key. The Set Supervisor Password window opens.

2Select Enter Current Password and type in the correct password. Then press the Enter key once to move to the Enter New Password field, type in a new supervisor password.

3Press the Enter key once to move to the Confirm New Password field. Retype the password you just entered to verify it.

4Commit your password to memory, and press the Enter key.

To remove password, do the following:

1Select Set Supervisor Password, and press the Enter key.

2Select Enter Current Password and type in the correct password, and finally press the Enter key thrice.

￿Note:

Make sure Password on boot is set to Enabled if you desire password protection at power on.

27

Page 35
Image 35
Lenovo 3000 G230 manual Select Set Supervisor Password, and press the Enter key