Lenovo X61S manual Recover to Factory Contents

Symptom-to-FRU index

Symptom or error	FRU or action, in sequence
1805	1. Remove the Wireless USB card that you
Unauthorized Wireless USB card is plugged	installed.
in—Power off and remove the Wireless USB	2. System board.
card.
1810	1. If the Access Predesktop Area has been
Hard disk partition layout error.	previously disabled, then go to the
	BIOS Setup Utility by pressing F1 to
	open the BIOS Setup Utility. Select
	Security --> Predesktop Area --> Access
	Predesktop Area. Set this item to
	Disabled. Save and exit.
	2. If the Access Predesktop Area has not
	been previously disabled, press Enter to
	load Access Predesktop Area. Then run
	RECOVER TO FACTORY CONTENTS
	in Access Predesktop Area.
	3. If item 2 failed, press F3 in the Welcome
	screen in RECOVER TO FACTORY
	CONTENTS. Run FDISK, and then
	delete all partitions. Run RECOVER TO
	FACTORY CONTENTS in Access
	Predesktop Area again.
	4. If item 3 failed, select CD-ROM boot in
	Startup in Access Predesktop Area. Boot
	from the Recovery CD and perform full
	recovery from it.
	5. If item 4 failed, replace the hard disk
	drive.
1820	Remove all but the reader that you set up
More than one external fingerprint reader is	for the authentication.
attached. Power off and remove all but the
reader that you set up within your main
operating system.
1830	Install DIMM in Slot-0, but not in Slot-1.
Invalid memory configuration—Power off	Note: For the construction of the DIMM
and install a memory module to Slot-0 or	slot, see“1040 DIMM” on page 64.
the lower slot.
2000	1. Undock docking station or port
Hard Drive Active Protection sensor	replicator if it is attached to the
diagnostics failed.	ThinkPad computer, and place the
Press <Esc> to continue.	computer on a horizontal surface. Do not
Press <F1> to enter SETUP	apply any physical shock to the
	computer.
	2. Run Diagnostics -->ThinkPad Devices
	-->HDD Active Protection Test.

50ThinkPad® X60, X60s, X61, and X61s