Lenoxx Electronics DVD-1002 manual Dvd, Remote Control

TROUBLE SHOOTING

Symptom Remedy

General	No button operates (on
	the main unit and/or the
	REMOTE CONTROL
	unit).
	Cannot change a menu
	item.
	Audio soundtrack and/
	or subtitle language is
	not at the initial settings.
	No subtitles.
	Alternative	audio
	soundtrack (or subtitle)
	Language	does not
	show.
	Angle cannot be
	changed.
DVD	Images appear distorted.

If your TV set does not have Audio / Video input jacks.

Picture is frozen.

Screen saver appears on TV screen.

Can not copy discs to VHS video tapes.

Picture is too short.

Progressive scan doesn’t work.

Press the ON/STANDBY button on the remote to set the player to the standby mode and then press the ON/STANDBY button again to turn the player to ON. Reset the DVD player by disconnecting the power plug and then re-connecting it (the player may not be operating properly due to lightning, static electricity, damaged or wrong discs, or some other external factors).

Try changing this item with the DVD door open (not during play).

If the audio soundtrack and / or subtitle language does not exist on the disc, the language selected at the initial setting will not be heard/seen. Try setting it up again, see Page 13.

Subtitles appear only on discs which contain them.

If subtitles don’t show, press the SUBTITLE button to display the subtitles.

An alternative language is not possible with discs which do not have more than one language. In the case of some discs, the alternative language cannot be selected by operating the AUDIO or SUBTITLE buttons. Try selecting it from the DVD menu if one is available.

This function is dependent on the DVD disc. Even if a disc has a number of angles recorded, these angles may be seen only on specific scenes.

If faces seem stretched and too long, your TV shape may be adjusted to 16:9 ratio. Please adjust it to 4:3 for better results or match to your TV type, see page 12.

1.Buy a newer TV with these jacks.

2.You may try using your VCR’s jacks but the color may be distorted due to macrovision licensed DVD protection (against copying discs).

3.Your dealer can sell you an RF Modulator which converts the signals for inputting into the TV’s RF input (antenna) jacks. However, your results will never be as good as a new modern TV with proper input jacks.

If a button is pressed too fast over and over, the signals may jam the circuits inside. To restore to normal, press STOP button and open the disc door to reset the circuits.

Turn off screen saver by pressing any button on the REMOTE control.

You can’t copy most commercial movie discs due to copy protection built into the disc.

Change the picture screen type, see page 12.

1.Check your cables if output matches input.

2.Does your TV support progressive scan? if not, use normal or S-Video jacks, set your player to S-Video output. (see page 14.)

23 IB-DVD1002 (AT)-WM-E-032706

IB-DVD1002(AT)-WM-E-032706.pmd 24

7/5/2006, 10:24 AM