SPEAKER SYSTEM CONNECTIONS
Tips for connecting the speaker wires
Unwind and stretch out the speaker wires attached with each speakers, then push and hold down the speaker terminal tab on the back of the main set to insert each wire. Make sure the wire is fully inserted, but the insulation is not covering the inserted part of the speaker wires.
To avoid short-circuiting the speakers
•Make sure the stripped end of each speaker wire does not touch another speaker terminal or the stripped end of
another speaker wire.
SPEAKER TERMINALS
Examples of poor connection of the 
speaker wires
PUSH AND HOLD THE COLORED TAB OF TERMINAL.
• | Stripped speaker wire is touching another speaker terminal. |
| Make sure not even 1 strand of wire touches the other |
| wire! |
WHILE HOLDING THE TAB OF THE TERMINAL, STICK
THE EXPOSED PART OF THE WIRE INTO THE HOLE
OF THE TERMINAL.
• Stripped wires are touching each other due to excessive removal of insulation. Do not allow the above to happen on your set.
REMOVE YOUR FINGER FROM THE TERMINAL TO LOCK THE WIRE INSIDE THE TERMINAL.
GO ON TO THE NEXT WIRE & REPEAT ABOVE.
MAKE SURE POWER IS OFF WHEN DOING THE ABOVE.
NOTE:
Be sure to match the speaker wire to the appropriate terminal on the back of the main set: (+) to (+) (color), and
NOTE: If longer wires are needed, you may buy any good quality speaker wire and splice the wires yourself. Please make sure the wires are not shorting to each other and observe the correct color polarity. Many speaker wires have a dotted line or solid line or raised rib on one side to identify each side.
Also make sure you use electrical tape to cover your splices.
9 |
