LevelOne FPS-3003 Methods for Setting the IP Address, Host Names and Host Name Rules

addresses. Besides, you can find Ethernet address that is located on the backside label of the server.

3.2.3IP Address

Unless you are assigning an IP address using DHCP, you must obtain an unused IP address from your network administrator.

3.2.4Methods for Setting the IP Address

You can set the IP address of your FPS-3003 USB MFP server using one of the following methods, depending on your network operating environment:

Automatic IP Address Assignment Manual IP Address Assignment

3.2.5Host Names and Host Name Rules

The host name of the FPS-3003 USB MFP server is specified by

“FPS-3003”in Factory Parameter. If you put two or more KMFP servers in your local area network, to avoid using same host names you have to change the host names by LevelOne MFP Control Center or server’s web pages. If your host name is longer than 15 characters, FPS-3003 USB MFP server limits the length of host name to 15 characters.

3.2.6Set the IP Address Using DHCP

Follow the instructions below to get an IP address using DHCP:

1.Edit or create a scope in the DHCP manager of the DHCP daemon. The entries included in this scope should contain the following parameters:

range of IP addresses subnet mask

default router IP address DNS server IP address lease duration

2.Activate the scope. The MFP server automatically gets the DHCP parameters. If you are using DNS, you may include at least one DNS server IP address in the DHCP scope or manually set DNS server IP in MFP server’s web pages or LevelOne MFP Control

11