LevelOne FPS-3003 user manual Tcp/Ip

USB Device Information: You can set printer names and display some information of USB mass storages and scanners. Please refer to Chapter 4, Chapter 6 and Chapter 7.

TCP/IP: You have to set the server’s TCP/IP configuration to connect TCP/IP network. Please see Chapter 3 Basic Installation for more details.

Supported Protocols: The server supports the following TCP/IP protocols:

TCP/IP

Enable LPR (Line Printer Remote) Printing: select or clear Enable LPR Printing support. It is enabled in Factory Default.

Enable IPP Printing: select or clear Enable IPP Printing support. It is enabled in Factory Default. Enable Raw TCP Printing: select or clear Enable Raw TCP Printing support. It is enabled in Factory Default and users may set the protocol’s TCP ports as following boxes:

-TCP Port 1: set TCP port for the printer of USB1 port

(default: 9100)

-TCP Port 2: set TCP port for the printer of USB2 port

(default: 9101)

Enable SMB (Server Message Block) Print/File Server: select or clear Enable SMB Print/File Server support. It is enabled in Factory Default.

Enable FTP Server: select or clear Enable FTP Server support. It is enabled in Factory Default and users may set some parameters as follows:

-FTP Port: type an integer number to set FTP

server’s TCP port (default: 21)

-Set Maximum Session Number: select or clear Set Maximum Session Number support. You can limit the FTP session number by selecting the support and type an integer to set the allowable maximum session number. If you clear the support, it means that FTP server will have not any limitation

57