Advanced Operations | Lexicon |
TV System Selection
| While you may want to set the |
| video output system (NTSC/PAL) |
| to the same as that supported |
P/N | by your TV, realize that the |
| Lexicon |
| convert any content that is not |
| in the correct format your TV |
understands. The default output is NTSC for North America.
Press the P/N button on the remote control to cycle the video output to PAL, NTSC or “Multi” system. The TV screen displays the selected system name.
Some points to keep in mind:
•When the video output is set to PAL or NTSC system, the player will convert the disc content to the selected system.
•When the video output is set to “Multi”, the player will not perform system conversion. The “Multi” mode is only to be used if your TV supports both NTSC and PAL systems.
•Most TV sets only support one of the NTSC or PAL systems. If the wrong output is selected, the TV may not display a picture. In this case repeatedly press the P/N button until a supported system is selected.
•The output system selected with the P/N button will be remembered when the player is turned off. The output system selection can also be done by setting the “TV System” item in the “Video Setup” section of the player’s Setup Menu. (Refer to page 52 for details.)
Output Resolution
The Lexicon
If you would like to change the output resolution, you may do so by pressing the RESOLUTION button on the remote control:
RESOLUTION | 1. Make sure the video cable is |
| |
| properly connected. |
2.Turn on the TV. Adjust the TV to use the proper input (HDMI, DVI or Component).
3.Make sure that the player is turned on. Although the output resolution can be changed “on the fly”, it is recommended that you stop playback and take out the disc before changing the output resolution. Press the RESOLUTION button. A “Resolution Setting” menu appears on the TV screen. In case the TV does not support the current resolution and you cannot see the “Resolution Setting” menu, the current resolution is also displayed on the front panel.
4.Use the UP/DOWN ARROW buttons to select the new output resolution. You may also press the RESOLUTION button multiple times to cycle through the available output resolutions. The new resolution is displayed on the front panel just in case you cannot see the “Resolution Setting” menu.
5.Press the ENTER button to apply the selected output resolution. Or, if you do not want to change the output resolution, press the RETURN button to exit.
The following output resolutions are available:
NTSC output via HDMI:
Auto → 1080p(60Hz/24Hz) → 1080i 60Hz → 720p 60Hz
→480p → 480i → Source Direct
PAL output via HDMI:
Auto → 1080p(50Hz/24Hz) → 1080i 50Hz → 720p 50Hz
→576p → 576i → Source Direct
34
