Lexicon Lexicon Part #070-13234 Restore Factory Defaults, Equalization, Bass and Treble Level

DC-1 Version 4 Digital Controller

System 2

Configuration System

Configuration

Restore

Factory Defaults

Although the DC-1 memory is cleared before it leaves the factory, it is good practice to restore the factory defaults with the following procedure before system configuration.

Turn the DC-1 OFF with the remote control. Turn the unit back ON and immediately press and hold the MUTE button on the remote. (Make sure you do not block the infrared receiver on the DC-1 front panel.) The display will read:

Press ▼ to highlight RESTORE DEFAULTS, then press SELECT. This will clear and reload all preset effects and all factory settings of Volume, Balance, Contrast, Configuration, etc. When the message FACTORY DE- FAULTS RESTORED is displayed, press DONE to return to normal opera- tion.

In the main menu, press SELECT to open the Equalization menu which contains Bass, Treble and Tilt controls, and a Loudness parameter.

Bass and Treble level controls are provided to compensate for inconsisten- cies in source material, rather than variations in room conditions. The BASS LEVEL control allows a boost or cut of as much as 6dB below 250Hz. The TREBLE LEVEL control allows a boost or cut of 6dB above 1.5kHz. To select either control for adjustment, use ▲ or▼ to select the control, press SELECT, and use ▲ or ▼ to adjust the setting.

These controls do not affect the sound of rear or side speakers.

Equalization

Bass and Treble Level

11