Lexicon Lexicon Part #070-13234 owner manual Customization, Balance Zone 2 Balance

DC-1 Version 4 Digital Controller

System Configuration

This control allows you to adjust the left/right balance of the front, side and rear main outputs. This control can also be accessed on the remote by pressing and holding the Shift button and using DONE to move to the left, and SELECT to move to the right.

This control allows you to adjust the left/right balance of the Zone 2 outputs. This control can also be accessed on the remote by pressing and holding the Record/Zone 2 button and using DONE to move to the left, and SELECT to move to the right.

After you have calibrated and customized the DC-1, there are two addi- tional steps recommended to safeguard the settings. First, document your adjustments using the table found at the end of this manual. Second, consider locking the settings so that they cannot be inadvertently changed. The last item in the Setup menu allows you to lock the DC-1 settings, as well as to change the name displayed during power up.

L/R Balance

Zone 2 Balance

Customization

Locking the settings allows full operation of the unit but prohibits the ability to change effect parameters or setup values. Specifically, with the settings locked, the unit will allow any Parameter or Setup menu to be displayed, but attempting to select any item for adjustment will display the message:

SETTINGS ARE LOCKED.

In order to prevent accidental changes, select the SETTINGS parameter and use ▲ to select LOCKED. A higher level of security can be achieved by simultaneously pressing Record/Zone 2 on the remote, then pressing FX ▲ (with SETTINGS selected). Repeat to release lock.

When the DC-1 is first turned on, it displays a copyright notice with the current software version. You can choose to have it display CUSTOMIZED FOR DEMONSTRATION with the word DEMONSTRATION scrolled in from right to left, or you can replace the word DEMONSTRATION with a custom name of as many as 20 characters. To assign a new name, use ▲ and

▼to highlight CUSTOM NAME. Press SELECT and press ▲ to turn this function ON, then press DONE.

You will return to the Lock Settings menu with ASSIGN CUSTOM NAME highlighted. Pressing SELECT will display the current name with a cursor indicating which character position can be modified. Use ▲ and▼ to select a new character. Use SELECT to move the cursor to a new position. Press DONE to save the new name.

Locking Settings

Assign Custom Name

31