4096-00X
Service Checks
Carrier Transport Service Check
| FRU | Action |
|
|
|
1 | System Board | Check the motor for binds, or loose motor pulley. |
|
| Turn the printer off and disconnect N6 from the |
|
| system board. Check for motor pins shorted to the |
|
| motor housing. If you find a pin shorted to the |
|
| housing, replace the motor. If the failure remains, |
|
| replace the system board. |
|
|
|
2 | Carrier Transport | A noisy or chattering motor or a motor that fails to |
| Motor | turn can be caused by: |
|
| • An open or short in the motor. |
|
| • An open or short in the motor driver on the |
|
| system board. |
|
| • A bind in the carrier transport mechanism. |
|
| With the carrier transport motor cable |
|
| disconnected from the system board, check for |
|
| zero to ten (0 - 10) ohms between the following |
|
| pins on the motor: |
|
| |
|
| |
|
| If the readings are incorrect, replace the motor. |
|
|
|
3 | Carrier Guide Rod | Clean the carrier rod. |
|
| Note: Lubricate the carrier guide rod and the |
|
| carrier rod bearing surface with grease P/N |
|
| 1329301. |
|
|
|
4 | Carrier Transport | Check for worn, loose or broken parts. Check for |
| Belt | obstructions blocking carrier movement. |
| Idler Pulley Parts |
|
| Carrier Frame | Carrier to carrier frame engagement should be |
|
| lubricated with grease P/N 1329301. |
|
|
|
Diagnostic Information
