4096-00X
Adjustments
The user is directed, in the Printer Control program, to perform the bidirectional alignment adjustments after replacing a print cartridge.
Removal Procedures
The following procedures are arranged according to the name of the printer part discussed. Unplug the power cord before removing any parts.
Releasing Plastic Latches
Many of the parts are held in place with plastic latches. The latches break easily; release them carefully. To remove such parts, press the hook end of the latch away from the part to which it is latched.
Access Cover Removal
1.Open the access cover.
2.Press both left and right side of the hinges to the center of the machine.
3.Remove the access cover from the front cover.
Base and Sheet Feed Assembly Removal
1.Remove the front cover.
2.Remove the five screws that secure the carrier frame to the base assembly and power supply ground strap.
3.Disconnect the power supply connector at the system board and cut the wire clamp on the left side.
4.Remove the carrier frame from the base assembly and lift it off the base.
5.Remove the two screws that secure the power supply to the base assembly.
6.Remove the power supply.
