6Press the up or down arrow button until appears next to the correct unit of measure, and then press .
Submitting selection appears, followed by the Universal Setup menu.
7Press and release until Ready appears.

Specify the paper height and width

Defining a specific height and width measurement for the Universal paper size (in the portrait orientation) allows
the printer to support the size, including support for standard features such as duplex print ing and printing multiple
pages on one sheet.
Note: Select Portrait Height to adjust the paper height setting or Paper Width to adjust the paper width
setting, or adjust both. Instructions to adjust both follow.
1From the Universal Setup menu, press the up or dow n arrow button until Portrait Width appears, and
then press .
2Press the left or right arrow button until the setting you want appears, and then press .
Submitting selection appears, followed by the Universal Setup menu.
3From the Universal Setup menu, press the up or dow n arrow button until Portrait Height appears, and
then press .
4Press the left or right arrow button until the setting you want appears, and then press .
Submitting selection appears, followed by the Universal Setup menu.
5Press and release until Ready appears.

Specify a feed direction

Short Edge is the factory default setting for feed direction for Universal paper settings. The Feed Direction menu
appears only when both the height and width specified for the Universal pap er size are set to 8.5 in (216 mm) or less.
If necessary, specify whether the short or long edg e of the paper enters the printer first.
1From the Universal Setup menu, press the up or down arrow button until Feed Directi on appears, and then
press .
2Press the up or down arrow button until Short Edge or Long Edge appears, and then press .
3Press and release until Ready appears.
Loading trays
1Pull the tray completely out.
Note: Do not remove trays while a job prints or while Busy appears on the display. Do ing so may cause a ja m.
Loading paper and specialty media
45