LG Electronics VCR Setup, When connecting with an antenna, When connecting with a RCA cable

Installation

VCR Setup

-To avoid picture noise (interference), leave an adequate distance between the VCR and TV.

-Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.

When connecting with an antenna

2

ANT IN

VCR

1 Connect the RF antenna out socket of the VCR to

the Antenna socket on the set.

ANT OUT S-VIDEO OUT

OUTPUT	(R) AUDIO (L) VIDEO
SWITCH
3 4	IN

1

ANTENNA

IN

CABLE

IN

2	Connect the antenna cable to the RF antenna in
	socket of the VCR.
3	Set VCR output switch to 3 or 4 and then tune TV
	to the same channel number.
4	Insert a video tape into the VCR and press PLAY
	on the VCR. (Refer to the VCR owner’s manual.)

When connecting with a RCA cable

VCR

	ANT IN
OUT	S-VIDEO ANT OUT
(R) AUDIO (L)	VIDEO OUTPUT
	SWITCH
IN	3 4

	1
AV OUT
	(MONO)
VIDEO	AUDIO	S-VIDEO	VIDEO	AUDIO
	AV IN 1		COMPONENT IN

1Connect the AUDIO/VIDEO jacks between TV and VCR. Match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red)

2Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner’s manual.)

3Select AV1 input source using the INPUT button on the remote control.

- If connected to AV IN2, select AV2 input source.

•If you have a mono VCR, connect the audio cable from the VCR to the AUDIO L/MONO jack of the set.

•This TV finds the connected input sources automatically for AV1, AV2 and Component 1-2. It is pre- sumed that RGB and HDMI/DVI sources are connected.

22