STEP 4: PREPARE THE WALL & UPPER CABINET
W A R N I N G 
To avoid personal injury or property damage, do not attempt to install this microwave oven if you cannot find a wall stud.
Measure And Track/Tape Up The Templates
1.Using a plumb line and measuring tape, find and mark the vertical center line on the back wall, as in Figure 24.
2.Find and mark one or two points where the studs are on the
wall. Then measure and mark the stud locations. If you cannot find any wall stud, consult a local building contractor.
CAUTION
DO NOT ATTEMPT TO INSTALL THE MICRO- WAVE OVEN IF YOU CANNOT FIND A WALL STUD.
3.Line up the plumb line on the wall with the center line on the mounting plate.
NOTE: Be sure the minimum width is 30 inches and the distance from the top of the wall template to the range or counter top is at least 30 inches. See Figure 24.
4.Center mounting plate in operating by lining up the plumb line on wall with centerline on mounting plate. Make sure the minimum width is 30 inches and that the top of the mounting plate is located a minimum of 30 inches above the cooking surface. See Figure 25.
NOTE: If the cabinets are not plumb, adjust the mounting plate to the cabinets. If the front edge of the cabinet is lower than the back edge, adjust the mounting plate to be level with the cabinet front.
5.Measure the bottom of the upper cabinet frame. Trim the edges A, B and C on the upper cabinet template so that the template will fit on the bottom of the upper cabinet. If upper cabinet has a recessed frame, trim the template so it fits inside the recessed area. Align the centerline of the upper cabinet template with the centerline of the mounting plate, then securely tape or tack the upper cabinet template in place. See Figure 25.
Figure 24
upper cabinet template
mounting plate
(1 piece mounting plate)
upper cabinet template
mounting plate
(3 pieces mounting plate)
Figure 25
– 12 –
