STEP 6: ATTACH THE OVEN TO THE WALL
5.Roof venting installation: See Figure 34.
Install ductwork through the vent opening in the
upper cabinet. Complete the venting system through the roof according to the method needed. See "Prepare The Venting System" STEP 2.
Use caulking gun to seal the exterior roof opening around the exhaust cap. See Figure 7 on page 8.
6.Use the power supply cord clamp to bundle the power supply cord. Install the power supply cord clamp, using a screw as shown in Figure 35, to the inside of the cabinet.
7.Grasp filter screen with one hand holding the ring and the other hand holding the opposite end. Insert the end of the filter screen without ring into the opening and slide towards the side of the microwave oven. Insert ring end of filter screen into the opening and slide entire screen towards the center of the microwave until screen is securely in position. Repeat for other filter screen. See Figure 36.
8.Plug in the power supply cord.
9.Read your Owner’s Manual, then check the operation of your microwave oven.
Figure 34
Figure 35
Figure 36
– 17 –
