Briggs & Stratton 273521, 271172, 270962, CE8069, 276535 manual Install Carburetor

Figure 20

6.Install new inlet needle (E, Figure 21) on float (D), then position float in carburetor body. Secure with new hinge pin (C) and center the pin between the float bosses.

NOTE: On Model 97700, install the flat disc (B) and main jet (A).

Figure 21

7.Place new bowl gasket on carburetor body and install fuel bowl. Place new fiber washer on fixed main jet (bowl nut) and install. Torque to values listed in Section 12 - Engine Specifications.

Install Carburetor

NOTE: Always replace air cleaner gaskets and carburetor mounting gaskets any time the carburetor has been removed for service.

1.Remove mounting screws from control bracket, if reinstalled.

2.Hook z-bend of governor link into grommet on top of the throttle shaft lever.

3.Place new gaskets or o-rings between control bracket (D, Figure 22), adapter (if equipped), and carburetor.

4.Position carburetor on control bracket or adapter and install screws (C). Torque to value listed in Section 12 - Engine Specifications.

4

Figure 22

NOTE: Use new screws or apply Loctite® to original screws to prevent loosening from vibration.

5.Connect the Choke-a-Matic® spring (if equipped) to choke lever

(A, Figure 23, Figure 24).

Figure 23

71