Briggs & Stratton 276535 On/Off Switch Light Does Not Flash, Engine Starts and Runs With Low Oil

2

On/Off Switch Light Does Not Flash

1.Check engine oil level. If low, add oil to bring to FULL mark on dipstick.

2.Try to start engine while shading ON/OFF switch light from bright light such as sunlight. If light does not flash, replace switch. If new switch still does not flash, go to next step.

3.Check wiring of ON/OFF switch. Wire from module with spade terminal should be on “L” terminal. RED ground wire should be on #3 terminal and BLACK wire from ignition armature should be on #2 terminal.

Engine Starts and Runs With Low Oil

1.Check wiring of ON/OFF switch per Step 3 in, “Engine Will Not Start and ON/OFF Switch Light Does Not Flash.” If wiring is correct, proceed to next step.

2.Check for oil sensor float stuck in open position per Step 2 in, “Engine Will Not Start, ON/OFF Switch Light Flashes.” If stuck, replace. If not stuck, proceed to next step.

3.Check for opens in wiring. If no opens. replace module.

50